69 datasets found

SDGSAT-1 satellite is designed for solar synchronous orbit, carrying three kinds of loads: high-resolution wide-width thermal infrared, low-light level and multispectral imager....

This dataset is the GPM Level 3 IMERG Early Daily 10 x 10 km (GPM_3IMERGDE) derived from the half-hourly GPM_3IMERGHHE.

The medium resolution sea ice drift product is a grid dataset. The grid has a spacing of 20 km on the polar stereoscopic projection map.

This parameter is the proportion of the grid frames covered by the cloud. Total cloud cover is a single-stage field of cloud computing that occurs according to different model...

This parameter is the northerly component of 10m wind. It is the horizontal speed at which the air moves northward, at an altitude of ten meters above the Earth's surface, in...

This parameter is the air temperature 2m above the surface of land, sea or inland waters. The 2m temperature is calculated by interpolating between the lowest model level and...

This parameter is a simplified representation of the amount of water evaporating from the Earth's surface, including transpiration (from vegetation), into vapor in the air above.

sentinel-1 is composed of two polar-orbiting satellites A and B, equipped with C-band SAR sensors, and belongs to the active microwave remote sensing satellite.

This parameter is the natural logarithm of the length of the heat roughness. The surface roughness of heat is a measure of the resistance of surface heat transfer. This...

The product is MODIS-L1B, the instrument-calibrated MODIS data product with the product number MOD02/MYD02, which was obtained on the Terra and Aqua satellites respectively and...

This parameter represents the average height of the top third of the surface ocean/waves generated by wind and waves.

The unit of this parameter is the PASCAL (Pa). The surface pressure is usually measured in hPa, sometimes expressed in millibar's old unit mb (1 hPa = 1 mb = 100 Pa).

NOAA 1/4° Daily Optimal Interpolated Sea Surface Temperature (OISST) is a long-term climate data record that incorporates observations from different platforms (satellites,...

The product is based on AMSR2(and AMSR-E) light temperature data and uses the ASI sea ice density algorithm to calculate daily near-real-time data products.

Depending on the temperature and salinity of the ice, the sea ice thickness is obtained from the SMOS L1C product, which is between 0.5-1 meters thick. The product complements...

Daily ice analysis chart, the product in yellow indicates marginal ice area (sea ice density ≤80%), and in red indicates dense floating ice (sea ice density > 80%).

High spatio-temporal resolution ice map ice water classification Remote sensing images (GF3, Landsat, Modis, Sentinel-1, SDG)

54°N-76°N, 171°E-165°W CTD, vertical resolution 1m

Results of permafrost area change in northern hemisphere based on 21 global model atmospheric data driven ground freezing index model

Latitude:89.8°~89.8°N; Longitude: 0.3°~359.8°S 0.5°× 0.5° Results of average permafrost extent variation in the Northern Hemisphere from 2016 to 2035 based on 21 global model...